Cyclone Recovery System800 CFM Jet Vacuum (Induction Vacuum) with muffler and 30 cubic foot vessel rated for 30” HG. The unit can be transported in a horizontal position and raised to the vertical position on-site. Easy handling with either forklift or crane.
|
|
Specs:
Length 11’-2” (Shipping position)
Height 5’-7” (Shipping position)
Width 5’-3” (Shipping position)
Width 5’-7” (Working position)
Length 5’-3” (Working position)
Height 11’-2” (Working position)
Weight 750 lbs. (Completely empty)
Features:
Vessel is rated for 30” HG (vacuum). Not rated for pressure.
Capacity, 30 cubic feet.
6” abrasive dump valve (butterfly) on bottom of vessel.
4” Suction inlet (Vacuum producer connection).
4” Abrasive recovery hose inlet connection.
Structural steel stand (legs) allows forklift access to drum and skid under the cyclone.
Certified, gross weight lifting eyes for handling with overhead crane.
Forklift pockets for handling when in the working position.
Abrasive dump valve height will allow dumping into 55-gallon drum with cover and skid.
800 CFM Jet (Induction) Vacuum with muffler.
Notes:
1. Not intended to be laid on its side with abrasive in the vessel.
2. Recovery hose and hose to connect vacuum producer to the cyclone tank are not supplied.
3. Optional high-level probe shut down circuit for vacuum producer may be available.
4. Tank must be stood upright with a crane or large (high lift) forklift at the job site.
Length 11’-2” (Shipping position)
Height 5’-7” (Shipping position)
Width 5’-3” (Shipping position)
Width 5’-7” (Working position)
Length 5’-3” (Working position)
Height 11’-2” (Working position)
Weight 750 lbs. (Completely empty)
Features:
Vessel is rated for 30” HG (vacuum). Not rated for pressure.
Capacity, 30 cubic feet.
6” abrasive dump valve (butterfly) on bottom of vessel.
4” Suction inlet (Vacuum producer connection).
4” Abrasive recovery hose inlet connection.
Structural steel stand (legs) allows forklift access to drum and skid under the cyclone.
Certified, gross weight lifting eyes for handling with overhead crane.
Forklift pockets for handling when in the working position.
Abrasive dump valve height will allow dumping into 55-gallon drum with cover and skid.
800 CFM Jet (Induction) Vacuum with muffler.
Notes:
1. Not intended to be laid on its side with abrasive in the vessel.
2. Recovery hose and hose to connect vacuum producer to the cyclone tank are not supplied.
3. Optional high-level probe shut down circuit for vacuum producer may be available.
4. Tank must be stood upright with a crane or large (high lift) forklift at the job site.